Installation

 Installation:

To ensure a professional and secure installation of your shutters, please follow these steps:

  1. Begin by determining the precise position for the shutter. Align the top and bottom of the shutter with the corresponding parts of the window and mark its placement accordingly.

  2. Once you have determined the desired position, mark the shutter itself at the locations where it will be fastened to the installation surface. Use a drill to create marks on the facade at the top, middle, and bottom of the shutter.

  3. Carefully remove the shutter and proceed to pre-drill pilot holes through the facade at the marked locations. It is recommended to apply a clear, waterproof, and paintable sealant to each pre-drilled hole to ensure a secure and weather-resistant installation.

  4. Fasten the shutter in place using non-corrosive exterior-grade screws. Be cautious not to over-tighten the screws, as this may cause damage or compromise the integrity of the installation.

***IMPORTANT: When installing the shutters on lap siding, it is crucial to adhere them to the highest point of the siding or utilize shims/spacers to fill any gaps and ensure a level installation.

FAQ's

What are some recommended fasteners?

Any exterior-grade screw will work with our pvc shutters. (Be sure to not over-tighten) For a more professional look check out the following suggestions

Stucco, brick: https://a.co/d/cA50DLe

Vinyl, wood: https://a.co/d/h06Q5Y8

How Many fasteners are required for each shutter?

Shutters smaller than 47” require 4 fasteners

Shutters larger than 47” require 6 fasteners 

Following these installation instructions will help you achieve a professional and secure mounting of your shutters, enhancing the overall appearance of your windows.